D-M-E — Button Mold Pressure Sensors

BS-412C 500 Pounds Force BS-413C 2000 Pounds Force Both Models Available in 12, 24 and 36 inch lengths
D-M-E Button Mold Pressure Sensors are used for measuring pressures in conjunction with auxiliary recording and control equipment in injection, die cast and transfer molds.They provide a full-scale output of 2 millivolts per volt of excitation.
Two Models
Available in 500 and 2000 pounds force.
Hermetically Sealed
Allows sensor to be used where moisture is present.
Permanently Installed
Minimizes damage due to mishandling of sensors.
Temperature Compensated
Special amplifiers that compensate for temperature
changes are avoided.
Constant Output Because each sensor is electrically identical, each sensor has the same output.This similarity practically eliminates the need to recalibrate the readout system when sensors are exchanged.Only a slight readjustment of the zero setting of the readout system may be required when exchanging sensors.Therefore errors in calibration are non-existent and operators will spend less time setting up control systems and recorders.
Small Size
Suitable for small molds or molds where water lines, support pillars, etc., inhibit the use of slide sensors.
Installation
The Button Sensor is usually installed under a 1/16 to 1/2 inch diameter ejector pin and the shielded lead wire is run to the outside of the mold for mounting.To accommodate the button sensor, a slot and counterbored hole is machined into the ejector plate.See installation information for details.